Kenworth T680 recalls
61 NHTSA safety recall campaigns cover the Kenworth T680, across model years 2011–2027. The latest was received on October 14, 2026.
Kenworth T680 recalls by model year
- 20274 campaigns
- 20262 campaigns
- 20259 campaigns
- 20247 campaigns
- 20239 campaigns
- 202210 campaigns
- 20217 campaigns
- 20208 campaigns
- 20199 campaigns
- 201815 campaigns
- 201711 campaigns
- 201616 campaigns
- 201511 campaigns
- 201413 campaigns
- 201313 campaigns
- 20122 campaigns
- 20112 campaigns
Check by VIN
A campaign rarely covers every Kenworth T680 of a given year. Enter your 17-character VIN to find the recall campaigns filed for your make, model and model year. The VIN is on the driver’s side of the dashboard (visible through the windshield), on the door-jamb label, and on your registration and insurance documents.
Is a recall still open on your vehicle? Only NHTSA’s official VIN check can say whether a campaign applies to your exact vehicle and whether the repair has already been done.
Your VIN is decoded with NHTSA’s public vPIC service to identify the make, model and year. It is not stored and is not added to any page address.
All Kenworth T680 recall campaigns
-
Seat belts
Bunk Restraint Webbing Not Secured Properly
-
Seats
Seat Ventilation Harness Can Cause Short Circuit
-
Electrical system
Oil Contaminated Power Distribution Center/FMVSS 103
-
Brakes
Incorrectly Installed Quick Release Valve/FMVSS 121
-
Electrical system
Instrument Panel Display Failure/FMVSS 101 & 121
-
Lighting
Insufficient Illumination from Lights/FMVSS 108
-
Electrical system
High Voltage Failure Can Cause Loss of Drive Power
-
Electrical system
Loss of ABS and Electronic Stability Control
-
Fuel system
Fuel Pump Failure May Cause Engine Stall
-
SteeringDo not drive
Broken Ball Stud May Cause Loss of Control
-
Steering
Steering Gear Shaft May Fracture
-
Power train
Improperly Crimped Connectors In Gear Shifter
-
Brakes
Insufficient Air Volume in Brake System /FMVSS 121
-
Steering
Steering Gear Assembled Incorrectly
-
Stability and traction control
Loss of Electronic Stability Control/FMVSS 136
-
Electrical system
Display May Freeze/FMVSS 101 & 102
-
Engine and cooling
Electrical Short Circuit May Cause Engine Stall
-
Fuel system
Fuel Tank Leak
-
Steering
Steering Gear Assembled Incorrectly
-
Steering
Steering Fasteners May Fail
-
Electrical system
Methane Detection System May Fail
-
Visibility
Windshield Defrost Failure
-
Engine and cooling
Flywheel Capscrews Not Tightened Properly
-
Brakes
Incorrect Rear Brake ABS Modulator Valve/FMVSS 121
-
Stability and traction control
Driver not Warned when ABS Offline/FMVSS 121, 136
-
Visibility
Mirror Glass May Detach
-
Parking brake
Cold Temperature may result in Parking Brake Delay
-
Suspension
Rear Axles Inadequately Lubricated
-
Power train
Vehicle may Move after Clutch Component Fails
-
Seat belts
Seat Belt may not Adequately Restrain Occupant
-
Lighting
Missing Reflex Reflectors on Markers/FMVSS 108
-
Engine and cooling
Fuel Line may Burst if Filter Screen Clogs
-
Stability and traction control
Driver not Warned when ABS Offline/FMVSS 121, 136
-
Electrical system
Gear Display may not be Accurate/FMVSS 102, 101
-
Power train
Unintended Vehicle Movement/FMVSS 102
-
Steering
Tie Rod may Loosen
-
Electrical system
Spotlight Circuit may not be adequately Protected
-
Fuel system
Fuel Pump May Fail
-
Fuel system
Plastic Fuel Fittings may Leak Fuel
-
Electrical system
Defective Engine Control Module may Cause Stall
-
Power train
10-Speed Manual Transmission may Remain in Reverse
-
Electrical system
Defective Engine Control Module may Cause Stall
-
Lighting
DRLs Override Hazard Lights/FMVSS 108
-
Brakes
Brake Valve Lines may be Improperly Connected
-
Power train
Driveshaft may Slip
-
Wheels
Rear Wheel Lug Nuts may be Loose
-
Electrical system
Alternator Charge Cable may Chafe
-
Power train
Rear Drive Axles may have Insufficient Lubricant
-
Parking brake
Improperly Seated Brake Chamber Diaphragm
-
Parking brake
Parking Brake Installed on Incorrect Axle
-
Seat belts
Seat Belt may be Difficult to Unlatch/FMVSS 209
-
Latches and locks
Door Latch may Prevent Door from being Opened
-
Lighting
Stop/Tail/Turn Lamp Housing/FMVSS 108
-
Electrical system
Ignition Switch may cause Unintended Engine Start
-
Seat belts
Seat Belt Buckle Attaching Cable may Fray and Fail
-
Electrical system
Exterior Lights Self Test Switch/Loss of Lights
-
Electrical system
Rear Suspension may Re-inflate with Key-off
-
Equipment
Upper bunk warning label deformation
-
Equipment
Upper bunk restraint buckle
-
Equipment
Bunk restraints/FMVSS 302
Showing the 60 most recent of 61 campaigns; pick a model year above for the rest.
Kenworth T680 recalls by component
- Electrical system 14
- Steering 6
- Power train 6
- Brakes 5
- Seat belts 4
- Lighting 4
- Fuel system 4
- Stability and traction control 3
- Parking brake 3
- Equipment 3
- Engine and cooling 3
- Visibility 2
- Wheels 1
- Suspension 1
- Seats 1
- Latches and locks 1
Campaigns are counted once, under the main component NHTSA filed them against.
Other Kenworth models
Common questions
Does the Kenworth T680 have recalls?
Yes. NHTSA lists 61 safety recall campaigns for the Kenworth T680, covering model years 2011–2027. Most involve electrical system, steering and power train.
Which Kenworth T680 model year has the most recalls?
On NHTSA’s records the 2016 Kenworth T680 has the most campaigns, with 16. A higher count does not by itself mean a less safe vehicle: some campaigns are small compliance fixes, and newer models have had less time to accumulate campaigns.
How do I find out if my Kenworth T680 is affected?
Choose your model year below to read each campaign, then check your VIN on NHTSA’s lookup. Campaigns usually cover a production range, so two cars of the same year can differ.