Kenworth T660 recalls
56 NHTSA safety recall campaigns cover the Kenworth T660, across model years 2004–2020. The latest was received on February 23, 2024.
Kenworth T660 recalls by model year
- 20201 campaign
- 20195 campaigns
- 20186 campaigns
- 20176 campaigns
- 201610 campaigns
- 201511 campaigns
- 201411 campaigns
- 20136 campaigns
- 20129 campaigns
- 201113 campaigns
- 201010 campaigns
- 200917 campaigns
- 200814 campaigns
- 20078 campaigns
- 20064 campaigns
- 20054 campaigns
- 20042 campaigns
Check by VIN
A campaign rarely covers every Kenworth T660 of a given year. Enter your 17-character VIN to find the recall campaigns filed for your make, model and model year. The VIN is on the driver’s side of the dashboard (visible through the windshield), on the door-jamb label, and on your registration and insurance documents.
Is a recall still open on your vehicle? Only NHTSA’s official VIN check can say whether a campaign applies to your exact vehicle and whether the repair has already been done.
Your VIN is decoded with NHTSA’s public vPIC service to identify the make, model and year. It is not stored and is not added to any page address.
All Kenworth T660 recall campaigns
-
Brakes
Insufficient Air Volume in Brake System /FMVSS 121
-
Seat belts
Seat Belt May Fail
-
Steering
Steering Fasteners May Fail
-
Stability and traction control
Driver not Warned when ABS Offline/FMVSS 121, 136
-
Power train
Vehicle may Move after Clutch Component Fails
-
Engine and cooling
Fuel Line may Burst if Filter Screen Clogs
-
Electrical system
No Warning to Driver if there are Engine Problems
-
Stability and traction control
Driver not Warned when ABS Offline/FMVSS 121, 136
-
Steering
Tie Rod may Loosen
-
Tires
Incomplete Tread Adhesion Causing Tire Separation
-
Electrical system
Defective Engine Control Module may Cause Stall
-
Electrical system
Defective Engine Control Module may Cause Stall
-
Lighting
DRLs Override Hazard Lights/FMVSS 108
-
Brakes
Brake Valve Lines may be Improperly Connected
-
Power train
Driveshaft may Slip
-
Wheels
Rear Wheel Lug Nuts may be Loose
-
Visibility
Water may Leak into Wiper Motor
-
Electrical system
Alternator Charge Cable may Chafe
-
Brakes
Improperly Torqued Brake Caliper Bolts
-
Parking brake
Improperly Seated Brake Chamber Diaphragm
-
Electrical system
Undersized Wire Gauge for Stop Lamp Circuit
-
Engine and cooling
Ice May Form in Intake Manifold
-
Parking brake
Parking Brake Installed on Incorrect Axle
-
Seat belts
Seat Belt may be Difficult to Unlatch/FMVSS 209
-
Lighting
Stop/Tail/Turn Lamp Housing/FMVSS 108
-
Electrical system
Ignition Switch may cause Unintended Engine Start
-
Brakes
Service brakes/antilock traction relay valve
-
Electrical system
Kenworth/peterbilt/fast idle control
-
Latches and locks
Kenworth/safety latch
-
Engine and cooling
Kenworth/peterbilt/combustion tube/caterpillar
-
Brakes
Kenworth/gunite/slack adjuster cast housing
-
Fuel system
Kenworth/peterbilt/centrifugal spinner cap
-
Latches and locks
Kenworth/hood strut safety latch
-
Power train
Kenworth/peterbilt/interaxle driveline failures
-
Equipment
Kenworth/door labels/part 567
-
Brakes
Kenworth/drive axle brake orientation
-
Engine and cooling
Kenworth/perterbilt egr valve seal oil leak
-
Lighting
Kenworth/chassis load center connection
-
Steering
Kenworth/peterbilt/steering shaft weld/trw
-
Latches and locks
Kenworth/hood strut safety latch retaining pins
-
Suspension
Rear axle outer end hub
-
Steering
Insufficient steering gear mounting bolt torque
-
Power train
Insufficient axle u-bolt torque on air glide
-
Steering
Steering shaft weld
-
Brakes
Drum brake assemblies
-
Brakes
Air disc brake caliper mounting fasteners/bendix
-
Suspension
Brake assemblies/airglide 400 rear suspension
-
Engine and cooling
Dpf bracket straps/caterpillar
-
Brakes
T-14 service brake chamber/bendix
-
Suspension
Axle u-bolts/suspension torque values
-
Latches and locks
Headlight harness routing/hood safety latch
-
Parking brake
Dash control valves/bendix mv-3
-
Latches and locks
FMVSS 206/trimark door latch
-
Steering
Steering gears/trw
-
Trailer hitch
Removable front tow hitch
-
Engine and cooling
Cracks in engine fan blade/horton
Kenworth T660 recalls by component
- Brakes 9
- Electrical system 7
- Steering 6
- Engine and cooling 6
- Latches and locks 5
- Power train 4
- Suspension 3
- Parking brake 3
- Lighting 3
- Stability and traction control 2
- Seat belts 2
- Wheels 1
- Visibility 1
- Trailer hitch 1
- Tires 1
- Fuel system 1
- Equipment 1
Campaigns are counted once, under the main component NHTSA filed them against.
Other Kenworth models
Common questions
Does the Kenworth T660 have recalls?
Yes. NHTSA lists 56 safety recall campaigns for the Kenworth T660, covering model years 2004–2020. Most involve brakes, electrical system and steering.
Which Kenworth T660 model year has the most recalls?
On NHTSA’s records the 2009 Kenworth T660 has the most campaigns, with 17. A higher count does not by itself mean a less safe vehicle: some campaigns are small compliance fixes, and newer models have had less time to accumulate campaigns.
How do I find out if my Kenworth T660 is affected?
Choose your model year below to read each campaign, then check your VIN on NHTSA’s lookup. Campaigns usually cover a production range, so two cars of the same year can differ.