2013 Toyota Venza recalls
NHTSA lists 4 safety recall campaigns for the 2013 Toyota Venza. Between them they involve air bags and equipment. The most recent was received on April 13, 2021.
-
Air bags
Side Curtain Air Bags May Not Deploy
The defect: Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2009-2015 Venza vehicles. The Supplemental Restraint System (SRS) wiring may become damaged with regular use of the driver-side door.
The risk: Damaged wires may cause the air bag sensor to become inoperable, preventing the deployment of the side and curtain air bags on the driver side and increasing the risk of injury during a crash.
The remedy: Dealers will inspect and, if necessary, replace the driver-side front door wire harness, free of charge. Owner notification letters were mailed October 19, 2021. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is 21TB01/21TA01.
-
Air bags
Clogged A/C Drain may cause Air Bags to Deploy
The defect: Toyota is recalling certain model year 2012-2013 Avalon, Avalon HV, Venza, Camry, and Camry HV vehicles. In the affected vehicles, the drain hose for the air conditioning condenser may become clogged causing water to accumulate at the bottom of the air conditioning condenser unit housing. The accumulated water may then leak through a seam in the housing onto the air bag control module potentially resulting in a short circuit of the module.
The risk: A short circuit may cause the air bags to become disabled or inadvertently deploy. An inadvertent airbag deployment can increase the risk of injury or the possibility of a crash. An inoperative airbag can increase the risk of injury in a severe crash. The power steering assist could also become inoperable resulting in increased steering effort and can increase the risk of a crash at low speeds.
The remedy: Toyota will notify owners, and dealers will seal the air conditioning condenser unit housing and install a protective cover on the airbag control module, free of charge. The recall began on February 5, 2014. Owners may contact Toyota at 1-800-331-4331.
-
Equipment
Inaccurate Load Carrying Capacity Labels
The defect: Southeast Toyota is recalling certain model year 2008 and 2010-2013 Toyota Tundra, 2010-2012 Rav4, 2012 Toyota Sequoia, 2010-2011 Toyota Corolla, 2010-2011 Toyota Camry and Camry Hybrid, 2010-2013 Toyota Highlander and Highlander Hybrid, 2010-2013 Toyota FJ Cruiser, 2011 Toyota Land Cruiser, 2010-2013 Toyota Venza, 2010-2011 Toyota 4Runner, 2010-2013 Toyota Tacoma, 2011-2012 Toyota Sienna, 2012 Toyota Prius, 2013 Scion FR-S, 2011 Scion XD, 2011 Scion XB, and 2012 Scion TC vehicles. These vehicles were sold with labels that were outside the allowable one percent of accuracy of actual weight added. Thus, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety…
The risk: An inaccurate label could lead to owners overloading their vehicles and tires. An overloaded vehicle can result in a tire failure which may result in a vehicle crash, personal injury, or property damage.
The remedy: Southeast Toyota will notify owners and provide a corrected label with instructions concerning its installation. A small group of the affected vehicles will need additonal remedies which are still being developed. The recall began on May 28, 2013. Owners may contact Southeast Toyota at 1-800-301-6859.
-
Air bags
Occupant Sensing System Calibration
The defect: Southeast Toyota Distributors, LLC (SET) is recalling certain models interspersed through model years 2009 through 2013 as follows: model year 2009-2012 Tacoma, 4Runner, Camry, Camry Hybrid, Prius, and RAV4; model year 2009-2010 Avalon, FJ Cruiser, and Highlander Hybrid; model year 2010-2013 model year Corolla, Sienna and Tundra; model year 2009-2013 Highlander and Venza; model year 2012 Prius V; and model year 2010-2012 Sequoia. During modification by SET to include accessories such as leather seat covers, seat heaters or headrest DVD systems, these vehicles may not have had the passenger seat occupant sensing system calibration tested. Without passing the calibration test, the occupant…
The risk: If the front passenger seat occupant sensing system is out of calibration, the front passenger airbags may not deploy or they may deploy inappropriately for the passenger's size and position. This could increase the risk of personal injury during the event of a vehicle crash necessitating airbag deployment.
The remedy: Southeast Toyota will notify owners, and dealers will test the sensitivity of the occupant detection sensors, and recalibrate them as necessary. The recall began on March 21, 2013. Owners may contact Southeast Toyota at 1-800-301-6859.
Check by VIN
A campaign rarely covers every Venza built in 2013. Enter your 17-character VIN to find the recall campaigns filed for your make, model and model year. The VIN is on the driver’s side of the dashboard (visible through the windshield), on the door-jamb label, and on your registration and insurance documents.
Is a recall still open on your vehicle? Only NHTSA’s official VIN check can say whether a campaign applies to your exact vehicle and whether the repair has already been done.
Your VIN is decoded with NHTSA’s public vPIC service to identify the make, model and year. It is not stored and is not added to any page address.
What 2013 Toyota Venza owners should do
- Check your VIN on NHTSA’s lookup to see which of these campaigns apply to your vehicle and whether any are still open.
- Call a Toyota dealer and book the repair, quoting the campaign numbers (21V-257, 13V-442, 13V-123, 13V-014).
- If you have bought the vehicle used, the recall still applies: the repair is free whoever owns the vehicle now.
- Make sure your current address is on file with the manufacturer so the owner letters reach you.
Other Toyota Venza model years
Common questions
Does the 2013 Toyota Venza have any recalls?
Yes. NHTSA lists 4 campaigns for the 2013 Toyota Venza: 21V-257 (Side Curtain Air Bags May Not Deploy); 13V-442 (Clogged A/C Drain may cause Air Bags to Deploy); 13V-123 (Inaccurate Load Carrying Capacity Labels); 13V-014 (Occupant Sensing System Calibration).
How do I know if my 2013 Toyota Venza has an open recall?
Enter your VIN in NHTSA’s recall lookup. Most campaigns cover only part of a model year’s production, and the lookup also shows whether the repair has already been done on your vehicle.
Will the dealer charge to fix the 2013 Toyota Venza?
No. Safety recall repairs are done free of charge by Toyota dealers. Quote the NHTSA campaign number when you book.