2019 Subaru Ascent recalls
NHTSA lists 9 safety recall campaigns for the 2019 Subaru Ascent. Between them they involve equipment, electrical system, power train, fuel system and engine and cooling and other systems. The most recent was received on July 7, 2026.
Safety advisory on one campaign
- Park outside: campaign 22V-907 — Improperly Fastened Ground Bolts May Cause Fire
-
Equipment
Incorrect Weight Rating on Label/FMVSS 110
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2026 Crosstrek Hybrid, 2025-2026 Forester Hybrid, Forester, and 2019-2026 Ascent vehicles. These vehicles were manufactured with an incorrect Gross Axle Weight Rating (GAWR) on the certification label. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) 110, "Tire selection and rims."
The risk: An incorrect GAWR label may lead to an overloaded vehicle, increasing the risk of a crash.
The remedy: Subaru will mail a new certification label to owners, free of charge. Owners may also choose to have a dealer install the new label, free of charge. Letters informing owners of the safety risk were mailed August 27, 2026. Additional letters will be mailed once the remedy is available. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WRH-26.
-
Electrical systemPark outside
Improperly Fastened Ground Bolts May Cause Fire
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019-2022 Ascent vehicles. The ground bolt that secures the ground terminal of the Positive Temperature Coefficient (PTC) heater may have been improperly fastened, which could result in melting of the ground terminal and surrounding components.
The risk: A melting ground terminal increases the risk of a fire.
The remedy: Owners are advised to park their vehicle away from structures and to avoid leaving the vehicle unattended while the engine is running. An owner who notices or smells smoke coming from the dash or driver's footwell area should immediately stop operating the vehicle and turn the ignition switch to the "Off" position. Dealers will replace the PTC heater ground bolts and if necessary, replace the ground wire and the connector holder, free of charge. Owner notification letters are expected to be mailed February 6, 2023. Owners may contact Subaru's customer service at 1-844-373-6614. Subaru's…
-
Power train
Drive Chain May Break Causing Loss of Drive Power
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019-2020 Ascent, 2020 Legacy and Outback vehicles. A programming error in the Transmission Control Unit (TCU) may allow the clutch to engage before the drive chain is completely clamped.
The risk: An improperly secured drive chain may slip and break, causing a loss of drive power and increasing the risk of a crash.
The remedy: Dealers will reprogram the TCU, inspect TCU data for chain slip, and visually inspect the chain guide. If evidence of chain slippage or damage is found, the transmission will be replaced. Repairs will be performed free of charge. Owner notification letters were mailed August 19, 2022. This recall includes all vehicles previously recalled under 19V-855. Vehicles previously recalled under 19V-855 will need to have the new remedy performed for this recall once available. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WRK-21.
-
Fuel system
Fuel Pump May Fail
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019-2020 Ascent, 2018 Forester, 2018-2020 Impreza, Legacy, Outback, 2018-2019 BRZ, WRX, and Toyota 86 vehicles. The low-pressure fuel pump inside the fuel tank may fail.
The risk: Fuel pump failure can cause an engine stall while driving, increasing the risk of a crash.
The remedy: Dealers will replace the low-pressure fuel pump, free of charge. Owner notification letters were mailed September 24, 2021. Subaru and Toyota owners may call customer service at 1-844-373-6614. Subaru's number for this recall is WRG-21.
-
Fuel system
Fuel Pump May Become Inoperative/Engine Stall
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019 Impreza, Outback, Legacy, and Ascent vehicles. The low pressure fuel pump may become inoperative.
The risk: If the low pressure fuel pump fails, the engine may stall without the ability to restart the vehicle, increasing the risk of a crash.
The remedy: Subaru will notify owners, and dealers will replace the low pressure fuel pump, free of charge. The recall began June 4, 2020. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WRD-20.
-
Engine and cooling
PCV Valve Can Separate
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019 Crosstrek, Forester, and Ascent vehicles. The aluminum Positive Crankcase Ventilation (PCV) valve can separate, allowing the separated components to enter the engine, resulting in a loss of power while driving.
The risk: An unexpected loss of power while driving can increase the risk of a crash.
The remedy: Subaru will notify owners, and dealers will inspect and replace the PCV valve, free of charge. If the PCV valve has separated and the components cannot be found, the short block engine will be replaced, free of charge. The recall began January 31, 2020. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WUW-08.
-
Power train
Incorrect Measurement of Hydraulic Fluid Pressure
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019 Ascent vehicles. The transmission hydraulic sensor may inaccurately measure the hydraulic fluid pressure.
The risk: If the fluid pressure is measured higher than its actual value, the hydraulic pressure will be reduced. If this occurs, the transmission drive chain may not have the proper tension, resulting in a loss of drive power and an increased risk of a crash.
The remedy: Subaru will notify owners, and dealers will reprogram the transmission control unit. The hydraulic sensor harness will be replaced on vehicles with certain stored diagnostic trouble codes. In addition, any vehicle confirmed to have experienced low drive chain tension will have the transmission assembly will be replaced. All repairs will be free of charge. The recall began January 31, 2020. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WUV-07.
-
Power train
Driveshaft may Disconnect
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019 Ascent vehicles. The center support bolts for the driveshaft may loosen, possibly resulting in the front portion of the driveshaft disconnecting.
The risk: If the front end of the driveshaft separates, it can increase the risk of a crash.
The remedy: Subaru will notify owners, and dealers will replace the driveshaft assembly, including the center support brace, free of charge. The recall began July 26, 2019. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WUI-94.
-
Body and structure
Missing Spot Welds in B-Pillar Area
The defect: Subaru of America, Inc. (Subaru) is recalling certain 2019 Subaru Ascent vehicles. These vehicles may be missing spot welds on, or around, the B-Pillar, compromising vehicle strength.
The risk: In the event of a crash, the missing spot welds may compromise the vehicle's strength, increasing the risk of injury.
The remedy: Subaru will notify owners, and dealers will inspect the vehicle to check for missing spot welds. If the welds are missing, the vehicle will be replaced, free of charge. The recall began July 31, 2018. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WTU-80.
Check by VIN
A campaign rarely covers every Ascent built in 2019. Enter your 17-character VIN to find the recall campaigns filed for your make, model and model year. The VIN is on the driver’s side of the dashboard (visible through the windshield), on the door-jamb label, and on your registration and insurance documents.
Is a recall still open on your vehicle? Only NHTSA’s official VIN check can say whether a campaign applies to your exact vehicle and whether the repair has already been done.
Your VIN is decoded with NHTSA’s public vPIC service to identify the make, model and year. It is not stored and is not added to any page address.
What 2019 Subaru Ascent owners should do
- Check your VIN on NHTSA’s lookup to see which of these campaigns apply to your vehicle and whether any are still open.
- Call a Subaru dealer and book the repair, quoting the campaign numbers.
- If you have bought the vehicle used, the recall still applies: the repair is free whoever owns the vehicle now.
- Make sure your current address is on file with the manufacturer so the owner letters reach you.
Other Subaru Ascent model years
Common questions
Does the 2019 Subaru Ascent have any recalls?
Yes. NHTSA lists 9 campaigns for the 2019 Subaru Ascent: 26V-436 (Incorrect Weight Rating on Label/FMVSS 110); 22V-907 (Improperly Fastened Ground Bolts May Cause Fire); 21V-955 (Drive Chain May Break Causing Loss of Drive Power); 21V-587 (Fuel Pump May Fail); and 5 more.
How do I know if my 2019 Subaru Ascent has an open recall?
Enter your VIN in NHTSA’s recall lookup. Most campaigns cover only part of a model year’s production, and the lookup also shows whether the repair has already been done on your vehicle.
Is it safe to drive the 2019 Subaru Ascent?
Campaign 22V-907 carries a “park outside” advisory. If your VIN is included in that campaign, follow the advisory until the repair is done.