2009 Toyota Camry Hybrid recalls
NHTSA lists 4 safety recall campaigns for the 2009 Toyota Camry Hybrid. Between them they involve visibility, air bags and speed control. The most recent was received on October 22, 2015.
-
Visibility
Power Window Master Switch may Melt
The defect: Toyota Motor Company (Toyota) is recalling certain model year 2009-2011 Tundra, Sequoia, Corolla, Corolla Matrix and Scion xB, 2008-2011 Highlander and Highlander Hybrid, 2007 Camry and Camry Hybrid, 2009 Camry and Camry Hybrid, 2006-2011 RAV4, 2006-2010 Yaris, and 2009-2010 Scion xD and Pontiac Vibe vehicles. During the manufacturing of the Power Window Master Switch (PWMS), grease lubricant may have been inconsistently applied to the sliding electrical contacts.
The risk: If the sliding electrical contacts are not protected by lubricant, debris and moisture that get into the switch may cause a short circuit and the switch assembly may overheat and melt, increasing the risk of a fire.
The remedy: Toyota will notify owners, and dealers will inspect the switch, applying a lubricant if no abnormality is found. If abnormality is found, the PWMS circuit board will be replaced, free of charge. The recall is expected to begin December 20, 2015. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is C0M.
-
Air bags
Occupant Sensing System Calibration
The defect: Southeast Toyota Distributors, LLC (SET) is recalling certain models interspersed through model years 2009 through 2013 as follows: model year 2009-2012 Tacoma, 4Runner, Camry, Camry Hybrid, Prius, and RAV4; model year 2009-2010 Avalon, FJ Cruiser, and Highlander Hybrid; model year 2010-2013 model year Corolla, Sienna and Tundra; model year 2009-2013 Highlander and Venza; model year 2012 Prius V; and model year 2010-2012 Sequoia. During modification by SET to include accessories such as leather seat covers, seat heaters or headrest DVD systems, these vehicles may not have had the passenger seat occupant sensing system calibration tested. Without passing the calibration test, the occupant…
The risk: If the front passenger seat occupant sensing system is out of calibration, the front passenger airbags may not deploy or they may deploy inappropriately for the passenger's size and position. This could increase the risk of personal injury during the event of a vehicle crash necessitating airbag deployment.
The remedy: Southeast Toyota will notify owners, and dealers will test the sensitivity of the occupant detection sensors, and recalibrate them as necessary. The recall began on March 21, 2013. Owners may contact Southeast Toyota at 1-800-301-6859.
-
Visibility
Power Window Master Switch may Melt
The defect: Toyota is recalling certain model year 2007-2009 Camry, Camry Hybrid, RAV4, Corolla, Corolla Matrix, Tundra, Sequoia, Highlander, Highlander Hybrid, Yaris, Scion xB, Scion xD and Pontiac Vibe vehicles. The power window master switch assemblies in some of these vehicles were built using a less precise process for lubricating the internal components of the switch assemblies. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat.
The risk: If the switch overheats, it may melt, possibly resulting in a fire.
The remedy: Toyota will notify its owners, and dealers will inspect the switch and apply a special grease that inhibits heat build up or replace any switch damaged by the defect, free of charge. Toyota owners that experience a problem with a switch should not attempt to make repairs, but should contact their Toyota dealer or the Toyota Customer Experience Center at 1-800-331-4331. General Motors will contact the Pontiac Vibe owners affected by this recall and GM dealers will inspect and repair switches as necessary. Those owners may contact Pontiac Customer Care at 1-800-762-2737.
-
Speed control
Pedal entrapment
The defect: Toyota is recalling certain model year 2004-2010 passenger vehicles. The accelerator pedal can get stuck in the wide open position due to its being trapped by an unsecured or incompatible driver's floor mat.
The risk: A stuck open accelerator pedal may result in very high vehicle speeds and make it difficult to stop the vehicle, which could cause a crash, serious injury or death.
The remedy: Toyota filed an amended defect report on november 25, 2009, stating that dealers will modify the accelerator pedal and, on certain vehicles, alter the shape of the floor surface under the pedal. These changes address the risk of pedal entrapment due to interference with the floor mat. Redesigned accelerator pedals will become available beginning in april 2010 and dealers will replace any modified pedal with the new pedal if desired. Also, dealers will replace any genuine toyota or lexus all-weather floor mats with redesigned all-weather mats, or repurchase the previous mats from owners who do…
Check by VIN
A campaign rarely covers every Camry Hybrid built in 2009. Enter your 17-character VIN to find the recall campaigns filed for your make, model and model year. The VIN is on the driver’s side of the dashboard (visible through the windshield), on the door-jamb label, and on your registration and insurance documents.
Is a recall still open on your vehicle? Only NHTSA’s official VIN check can say whether a campaign applies to your exact vehicle and whether the repair has already been done.
Your VIN is decoded with NHTSA’s public vPIC service to identify the make, model and year. It is not stored and is not added to any page address.
What 2009 Toyota Camry Hybrid owners should do
- Check your VIN on NHTSA’s lookup to see which of these campaigns apply to your vehicle and whether any are still open.
- Call a Toyota dealer and book the repair, quoting the campaign numbers (15V-689, 13V-014, 12V-491, 09V-388).
- If you have bought the vehicle used, the recall still applies: the repair is free whoever owns the vehicle now.
- Make sure your current address is on file with the manufacturer so the owner letters reach you.
Other Toyota Camry Hybrid model years
Common questions
Does the 2009 Toyota Camry Hybrid have any recalls?
Yes. NHTSA lists 4 campaigns for the 2009 Toyota Camry Hybrid: 15V-689 (Power Window Master Switch may Melt); 13V-014 (Occupant Sensing System Calibration); 12V-491 (Power Window Master Switch may Melt); 09V-388 (Pedal entrapment).
How do I know if my 2009 Toyota Camry Hybrid has an open recall?
Enter your VIN in NHTSA’s recall lookup. Most campaigns cover only part of a model year’s production, and the lookup also shows whether the repair has already been done on your vehicle.
Will the dealer charge to fix the 2009 Toyota Camry Hybrid?
No. Safety recall repairs are done free of charge by Toyota dealers. Quote the NHTSA campaign number when you book.